Heaty Heater Control Module

Heaty is the central interface to your parking heater in the Camper Jarvis system. Set target temperature, timers and operating mode from the SmartKnob or the dashboard, both equal, both in sync, entirely local in the vehicle with no cloud and no app required.

One place for everything

Every heater comes with its own small control panel in its own corner of the van. Heaty brings the heater to where your lighting, water and power already live: one interface for the whole vehicle, no brand-specific display, no separate app.

You choose the sensor that matters

When you create the widget you decide which temperature sensor Heaty uses, for example the SmartKnob's internal sensor in the living area rather than a probe at the heater itself. That way you heat to the temperature where you actually sit and sleep.

Plug and play, not adapter hunting

The matching wiring harness for the heater you select is always included: Autoterm, Timberline or Webasto. Heaty draws its power through that harness directly from the heater, so no extra supply cable is needed. As soon as the heater has power, Heaty starts looking for a SmartKnob in pairing mode.

Automations are where it gets good

Link Heaty to your scenes and schedules: warm up before the alarm goes off, set back at night, or start heating automatically when a certain temperature is reached. You keep full manual control at any time.

Currently supported

• Autoterm 2D / 4D
• Timberline 1.0 & 2.0
• Webasto Air Top

In preparation

• Eberspächer
• Alde
• Truma

One Heaty per heater. If you run two independent heaters, install a second Heaty. Each one stays individually controllable and can be used separately in scenes and automations.

More in our knowledge base

Step by step, in German: Standheizung im Camper smart steuern, plus the guides for Autoterm, Timberline and Webasto Air Top.